How To Clean Maytag Washer Filter Top Load

Aceder Authors

3 min read

·

23-11-2024

45

0

Share

Cleaning your Maytag top-load washer's filter is crucial for maintaining its efficiency and preventing costly repairs. A clogged filter restricts water flow, leading to poor cleaning performance and potential damage. This guide provides a step-by-step process to clean your Maytag top-load washer filter, ensuring your machine runs smoothly for years to come.

Understanding Your Maytag Top-Load Washer Filter

Before we begin, it's important to locate the filter. Maytag top-load washers typically have the filter located at the bottom of the washing machine, usually accessed through a small panel or door. Consult your owner's manual for the exact location and instructions specific to your model. The filter itself is a small, usually plastic component that traps lint, debris, and other small items that could damage the washing machine's pump.

Tools and Materials Needed

Before starting, gather the following:

• Shallow pan or container: To catch any spilled water.
• Clean rags or towels: To wipe up spills and clean the filter.
• Screwdriver (if needed): Some models require removing a small access panel.
• Maytag top-load washer filter: While cleaning it, it's good to have a replacement on hand, just in case. Your owner's manual will specify whether your model requires a specific filter.

Step-by-Step Guide to Cleaning Your Maytag Washer Filter

1. Disconnect the Washer: Turn off your washing machine and unplug it from the power outlet. Safety first!

2. Locate the Filter: Refer to your owner's manual to find the exact location of the filter access panel. It's usually on the bottom front of the machine.

3. Access the Filter: Carefully remove the access panel. This may involve unscrewing a panel or simply pulling it off. Be gentle to avoid damaging any parts.

4. Prepare for Water: Place a shallow pan or container under the filter access area. Some water might leak out when you remove the filter.

5. Remove the Filter: Carefully remove the filter. It may be necessary to gently twist or pull it free.

6. Clean the Filter: Rinse the filter thoroughly under running water. Use an old toothbrush to remove any stubborn debris trapped inside the filter.

7. Inspect for Damage: Examine the filter for any cracks, holes, or other signs of damage. Replace the filter if you find any damage.

8. Clean the Filter Housing: Use a damp cloth or sponge to wipe down the inside of the filter housing. Remove any accumulated lint or debris.

9. Reinstall the Filter: Carefully place the cleaned filter back into its housing. Make sure it's securely in place.

10. Reattach the Access Panel: Replace the access panel and secure it tightly.

11. Reconnect the Washer: Plug the washing machine back into the power outlet.

How Often Should You Clean Your Maytag Washer Filter?

The frequency of cleaning your Maytag washer filter depends on several factors, including how often you use the machine and the types of loads you wash. As a general guideline, cleaning every 3-6 months is a good practice. However, you should clean it more often if you notice a decrease in washing machine performance, such as poor water flow, longer wash cycles or unusual sounds.

Troubleshooting

Q: Water is still leaking after cleaning. A: Ensure the filter is properly seated. Check the filter housing for cracks or damage. If the problem persists, contact a Maytag repair technician.

Q: My filter is damaged. A: Replace the filter with a new one from a Maytag authorized dealer. Using a damaged filter can cause further damage to your washer.

Q: I can’t find the filter. A: Consult your owner's manual for the exact location and instructions specific to your model.

By following these steps, you can keep your Maytag top-load washer running smoothly and efficiently. Remember regular maintenance is key to extending the life of your appliance. Remember to always consult your owner's manual for specific instructions related to your model.